All electronics will fail with age. A significant chunk of the failures are due to electrolytic capacitor failure. These components are virtually guaranteed to fail eventually, even under normal...
Memory Adapter Installation Instructions: the Moates.Net 'G1' Adapter
(edited from Allan Reinke's review on www.iroczone.com)
(works on all your TPI setups, the 1992-93 LT1, and some late-model...
G1 Chip adapter picture
Overview
The G1 is an adapter that allows a chip or emulator to be plugged into OBD1 memcal based GM PCMs.
The GP1 kit is a G1 chip adapter and two 27SF512 flash chips ...
G2 TBI-Style 2732-to-29C256 Adapter Installation Instructions:
Here is a pictorial depiction of a G2 installation in a TBI-style ECM. It shows the following:
1) Disassembly and removal of stock s...
G2 TBI-Style 2732-to-29C256 Adapter Installation Instructions:Here is a pictorial depiction of a G2 installation in a TBI-style ECM.It shows the following:
1) Disassembly and removal o...
Moates.Net G3 Switching Adapter Installation Instructions
The 'G3' Switching Adapter
(also: Using the 'EX' with the G3)
For placing several different binaries on a single chip for GM applicat...
The ‘G3’ Switching Adapter
(also: Using the ‘EX’ with the G3)
Note: This product was updated in 2015. The original documentation (which still applies) follows with a discussion of differences bet...
by keebler65 on UberData
http://home.mn.rr.com/keebler65/honda
Intro
Uberdata is basically a FREE piece of software that enables you to modify your Honda ECU's code using a Windows-based program...
This is Keebler65’s old guide. Some of the chipset and software info is a bit dated, but the techniques are good.
ECU Chipping
You need to add a few additional components to the original Honda ECU...
You will need bridge J1 on the back of the ECU.
Add C49 & C50 and C91 & C92 on back
C49 & C50 –> .004UF (Digikey part number 399-1230-1-nd )
C91 & C92 –> .00001UF ( digikey...
Hulog/Hondalog
Installation of Honda-Based USB Datalogging Tools
There are two tools available for datalogging on Honda ECUs from www.moates.net and they include the HULOG and...
Versions
This is the documentation for the Nissan Boards. At this point, there are only one version of the boards, 1.1nm As future revisions to the board are produced, this page will be updated....
The hardware portion of the NEMU tuning package requires installation in an ECU to be functional. This install is NOT for beginners, although it is not extremely difficult with the correct tools....
This page is here to add VTEC capability to your otherwise non-VTEC ECU.
The reason we are able to do this, is because when Honda designed their ECUs, the boards for the P05, P06, P28, etc were ba...
